Wholesale P3 LED Screen Factories – Indoor P1.8 High Refresh Rate LED Display Module – Jucai

Remarks & Key Precautions

1.For indoor Q1.8 Pro, pixel is relative small, we suggest to go with 640*480mm MG cabinet, cabinet model is QM-Pro-2.
2.Indoor Q1.8 Pro uses HUB75E, and there is only input port, not output port.
3.Temperature requirement:

• 1) Storage temperature range: -10℃-30℃, over 30℃ needs to do cooling treatment. Lamp surface temperature(working period): ≤60℃, temperature control equipment is required to be installed when temperature exceeding the standard.

4.Humidity requirement:

• Storage humidity range: 10% RH-60% RH, humidity over 60% RH requires dehumidification treatment.

5.Keep away from water: Indoor products have low level of protection, water can make the module short circuit, and leads to circuit device damage, so it is necessary to keep away from the water source.
6.Storage humidity range: 10% RH-60% RH, humidity over 60% RH requires dehumidification treatment. Operating humidity range: 10% RH-65% RH, If the humidity exceeds the standard, it must be dehumidified before it can be used normally.
7.After the heavy rain, the display screen should be checked in time to see whether there is dampness, water droplets, water vapor and other problems inside the display screen. If problems are found, they should be dealt with in time to reduce the damage caused by the wet environment to the display screen.
8.The display installation site needs to be equipped with a thermometer and hygrometer to monitor the surrounding environment of the display in time.

Application

Q1.8 Pro, Taxation Administration Showroom, 42sqm